Tira

Bitmonster · **Joined:** Mon Feb 06, 2006 11:28 pm **Posts:** 2236

Post your questions and comments for the Tira plugin here.

tentree · **Joined:** Mon Oct 29, 2007 6:14 am **Posts:** 0

Is it possible to get a computer out of standby (ACPI state S3) using EventGhost with a Tira-2?

The following post describes how to do it with Girder but I don't see anything comparable with EventGhost's Tira plugin.

http://www.promixis.com/forums/archive/ ... -6004.html

Bitmonster · **Joined:** Mon Feb 06, 2006 11:28 pm **Posts:** 2236

The API of the Tira doesn't allow this from a plugin. But you can try the "Ira-3 Configuration Utility" from this page:
http://www.home-electro.com/support.php#Downloads

cncb · **Joined:** Sat Sep 12, 2009 11:25 pm **Posts:** 4

I am trying to use my Tira IR receiver with a wireless remote control extender to control my PC from a different room. It works fine for several hours and then totally locks up unexpectedly. I am 100% sure that the Tira is causing the lockups because when I unplug the Tira the lockups go away and I also have tried it on different PCs, in Vista and Win7, using Eventghost and Girder and still get the lockups. I don't know if the remote control extender is causing the issues or not but maybe the Tira is getting overloaded somehow?? I have the latest drivers for the Tira. Any ideas? Thanks.

Sega · **Joined:** Mon May 25, 2009 9:00 am **Posts:** 1

I'm using TIRA and when I enable the tira plugin the processor load increases and stays high.
The load is not directly coming from the EventGhost but through DPC (Deffered Procedure Calls) part of the system processes.

If the plugin is not enabled the proc load comes immediately down to about 3-4%.
If the plugin is enabled it fluctuates between 40 to 60%.

Any suggestion?

Suchetan · **Joined:** Sat Oct 24, 2009 4:31 am **Posts:** 2

How do I set up Tira to work with Eventghost?

EventGhost

Tira

Who is online